Se-electronics sE4 Stereo Pair User Manual download pdf

sE4a Stereo Pair – Technical Information

A matched stereo pair of sE4 mics with stereo bar and sE’s new black Aluminium, steel reinforced,

ightcase.

The sE4 pair replaces the sE3 pair. The mic is a remodelled sE3, designed to sound and perform exactly

the same, and with very similar styling, but with one key new feature. The chassis has been re-engi-

neered to accept 2 additional interchangeable capsules, a Hypercardioid and an Omni.

Please note: The sE4 mic comes with the Cardioid capsule as standard. The Hypercardioid and Omni

capsule set is available as an additional purchase for both single and matched stereo pair sE4 mics.

The sE4 has been renamed, despite its similarity to the existing sE3, to avoid confusion, since the new

capsules will NOT t on the current sE3 model. Both single and matched pairs of mic and capsule sets

are available, and the packaging has also been updated with sE’s new hi spec black Aluminium, steel

reinforced, ight cases. All sE4 packages ship with full suspension shock mounts included.

Technical Specications

Acoustical operating principle: Pressure gradient

transducer

Maximum SPL for THD 0.5%2): 127 dB (cardioid)

Directional pattern: Cardioid Maximum SPL for THD 0.5% with

preattenuation2) :

137 dB

Frequency range: 20 Hz ... 20 kHz Maximum output voltage: 1200 mV

Sensitivity at 1 kHz into 1 kohm: 25 mV/Pa1) Dynamic range of the microphone

amplier (A-weighted):

112 dB

Rated impedance: 200 ohms Supply voltage (P48, IEC 61938) : 48 V ± 4 V

Rated load impedance: 1 kohms Current consumption (P48, IEC 61938): 4mA

Equivalent noise level, CCIR1) : 28dB Matching connectors: XLR3F

Equivalent noise level, A-weighted1): 15dB-A Weight: 280g

Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL): 65 dB Diameter: 28mm

Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL): 78 dB Length: 178 mm

125Hz

250Hz

500Hz

1KHz

2KHz

4KHz

8KHz

16KHz

1) According to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS

2) Measured as equivalent el. input signal

Polar pattern and Frequency Chart

Cardioid

sE Electronics

www.seelectronics.com

Technical Specications 1

Summary of Contents

Page 1 - Technical Specications

sE4a Stereo Pair – Technical InformationA matched stereo pair of sE4 mics with stereo bar and sE’s new black Aluminium, steel reinforced, ightcase.Th

Comments to this Manuals

No comments

Se-electronics sE4 Stereo Pair User Manual

Browse online or download User Manual for Microphones Se-electronics sE4 Stereo Pair. sE Electronics sE4 Stereo Pair User Manual

Summary of Contents

Comments to this Manuals